13-1 Parker Hannifin Corporation Catalog PH001/NA O-Rings 13 Buna-N N1470 OBAG 1/32” 001 to 002-1/16” 003 NBR Elastomer 70 Durometer Black 1/32” FRACtiONAl (0.040” ACtuAl) CROss

Use our Extrusion Chart to determine if the maximum recommended pressure of an O-ring seal based on your seal hardness and gland clearance.. ss 6/4/

Static Male and O-ring Seal Design . Design Chart 4-2 and its accompanying Design Table 4-2 (available by clicking on the chart image at the bottom of the page) give one set of dimensions for static O-ring seals when the configuration is similar to a piston or rod application with no motion involved.. For applications requiring more than two or three percent stretch on the inside

Reference the Parker o-rings size chart to help determine the size for your application. The chart provides dimensions, both nominal and metric, for standard (AN) shrinkage materials ONLY.

Nominal (inches) Nominal (inches) Nominal (inches) Actual (inc Parker Size AS568A; Size ID OD W ID 2‑001 ‑001 1/32 3/32 1/32 .029 2‑002 ‑002 3/64 9/64 3/64 .042

Back-up rings are anti-extrusion elements designed to prevent the migration of sealing material into the extrusion gap under the system pressure. They are open or closed shapes for snap assembly made of a wide range of compounds which are highly resistant to thermal or mechanical stress.

Ace Seal offers a full line of custom and standard Parker 500 Series O-Rings available in a variety of sizes, elastomers, material and 

First find the chart for the O-ring cross section size: 0.070”, 0.103”, 0.139”, 0.210” and 0.275”. Next, locate the O-ring compression or squeeze on the x-axis of the chart. Moving vertically to either the 70 or 90 durometer band, you will find the expected range of

7-2 Parker Hannifi n Corporation • O-Ring Division 2360 Palumbo Drive, Lexington, KY 40509 Phone: (859) 269-2351 † Fax: (859) 335-5128 www.parkerorings.com Compatibility Tables for Gases, Fluids, Solids Parker O-Ring I 5700 Handbook Nitrile NBR Hydrogenated Nitrile HNBR Ethylene Propylene EPDM Fluorocarbon FKM Hifl uor FKM Perfl

ISO 6149 specifies o-rings designed for use in Metric Tube Fittings. Includes 13 different sizes and calls out the metric thread size for each o-ring size. IS0 6149 Size Chart View Size Chart Generic Metric O-Ring Sizes Included are the most common metric sizes matching up with any corresponding international standard sizes.

II Table of Contents Parker O-Ring & Engineered Seals Division 2360 Palumbo Drive Lexington 40509 Phone: (859) 269-2351 Fax: (859) 335-5128 www.parkerorings.com WARNING: These